little giant sewage ejector pump systems

Little giant sewage ejector pump systems series#

In fact, in most cases a Sewage Ejector pump is the much better option. Little Giant LG-SEW75T 115 Volt, 3/4 HP, 8400 GPH Cast Iron Sewage Pump with Tethered Switch and 20-Ft. In summary, not all sewage handling pumps are Grinder Pumps and a Sewage Grinder pump is not always necessary to pump raw sewage. You have a low vertical distance to lift the water (under 70 feet).There is no minimum head requirement on these units and they include the same cutting action of the larger commercial grinder pumps but with a smaller 1.0 HP motor.

Little giant sewage ejector pump systems series#

When pumping sewage short distances (750 feet or less) The Liberty ProVore, Little Giant 16G, and Zoeller Shark 800 series pumps are all specialty units designed to be used in place of residential 4/10 to 1.0 HP sewage ejector pumps.

When pumping sewage to a gravity sewer main.

You have a high vertical distance to lift the water (minimum of 30 feet)īelow are the scenarios when a Sewage Ejector Pump will work best:.

These sewage pump systems have the ability to handle both liquids and solid waste up to 2' diameter where a gravity system will not work, such as in septic systems that.

When pumping a very long distance (1000 feet or more) A simplex sewage pump system is used in the collection of sewage, effluent, drainage, toilet and seepage water, evacuation for homes, farms, light commercial and industrial use.

When pumping to a pressurized sewer main.

You should only use a Sewage Grinder Pump when one the following apply to your application: Therefore, if you are not pumping into a shared sewer main or have less than 30 feet of head, you do want a Sewage Ejector pump not a Sewage Grinder pump. Do not overtighten or the fittings may crack. Once bonded, thread the adapter-end of the PVC pipe onto the sewage ejector pump using a wrench to tighten. Attach the male-threaded adapter to one end of the PVC pipe using the primer and PVC cement. If they do not have to pump against at least this much back pressure, the motor will begin to spin at an extremely high rate of RPMs causing it to burn up fairly quickly. Step 4: Attach Adapter and Pump to Discharge Pipe. PLEASE NOTE: Grinder pumps must be used in scenarios where there will be at least a minimum of 30 feet of head pressure put on them. The units without internal capacitors require a special control panel with built in capacitors to operate the pump. Work through the five steps below to size the system: System capacity (gpm required) Total head Pump selection Solids handling Basin size Simplex/Duplex system Wastewater Call MSC today to learn about the latest LittleGiant products. These require no control panel for operation. sewage pump and applicable systems to use in sewage ejectors.

The most commonly used forms are with internal capacitors. Each model comes in two forms, one with internal capacitors and one without internal capacitors. Selected models feature bolted down covers for a leak-tight seal, non-clogging vortex impellers for processing solids and basins filled with environmentally safe peanuts for damage-free transit. For use in residential, commercial, industrial and agricultural applications with light to medium. These powerful 1/2 HP submersible sewage ejector pumps have a flow rate of 6000 gph 10 head pressure (which is equivalent to 100 gallons per minute) and. Raptor Supplies offers a wide array of Liberty Pumps, Little Giant & Zoeller pump systems. They are available in both Little Giant and Ashland Pump brands. The Little Giant 14S-CIM 1/2 hp submersible pump is specifically engineered to handle the tough, demanding tasks of effluent and sewage waste transfer with high-efficiency and long-term dependability. The second is to pump over extremely long distances, or up over very high elevation changes.Īll of our Grinder Pumps start at 2.0 HP and have 1-1/4’’ NPT discharges. We have something for any application - above grade, below grade, indoor, outdoor, self-contained - you name it, we've got it We are your source for sewage ejection products and thousands of other plumbing-related products. The first is to pump from a residence into a shared pressurized sewer main. offers an impressive selection of sewage ejection packages and pumps. There a couple of applications that these pumps are normally used in. These pumps can grind up sewage into a slurry and pump it at a very high pressure to its destination. However, Sewage Grinder pumps are much more powerful. Pre-Assembled: 20'x30' Polyethylene Basin with stub out intake, 1-Piece Structural Foam Bolt-on Cover, 2' discharge, 2' vent, with 10SC-CIM Sewage Pump (Item 511432) 115V 1/2HP, piggyback mechanical float switch and float tree and includes finish cover.Sewage Grinder pumps are designed to handle raw sewage pumping jobs, just like the Sewage Ejector pumps.